Fisher & Paykel RX216 Instructivo De Instalacion Y Guia Del Usuario página 44

Troubleshooting
42
Ice and water
Problem
Ice maker is
not producing
enough ice or ice is
malformed.
Ice forms in inlet
tube to ice maker.
Refrigerator is
leaking water.
Possible causes
Ice maker has just been
installed or a large amount
of ice has been used.
Water pressure is too low.
Water filter is clogged or
needs to be changed.
Water pressure is too low.
Saddle valve not open
completely.
Freezer temperature is too
high.
Plastic tubing was used to
complete water connection.
Improper water valve was
installed.
What to do
Wait 24 hours for ice production to begin or
for ice maker to restock after emptied.
Low water pressure can cause valve to leak.
Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per square
inch is recommended for refrigerators with
water filters.
Change water filter (see page 25).
Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per square
inch is recommended for refrigerators with
water filters.
Open saddle valve completely.
See temperature controls, page 12 or 16.
Freezer temperature should be between 0° to
2° F (-18° to -17° C).
It is recommended copper tubing is used
for installation. Plastic is less durable and
can cause leakage. The manufac turer is not
responsible for property damage due to
improper installation or water connection.
See connecting the water supply,
pages 9 – 10. Self-piercing and 3⁄16" (4.7 mm)
saddle valves cause low water pressure and
may clog the line over time. The manufacturer
is not responsible for property damage due to
improper installation or water connection.