ZebraBlinds Cordless Faux Wood Manual Del Usuario página 4

1 2 3
For Outside Mounts, we recommend that you place a bracket
on both ends of the head rail, use tape to hold the brackets in place
if necessary (do the same for the center support(s) if applicable).
Hold the blind level at the height desired and center it over the
window opening — mark the exact location of each bracket with a
pencil, and then attach the brackets as described above.
For 2-in-1 Window Opening – the Dual Bracket illustrated below is
attached at the center of the window to join the two blinds.
view from top
Securing the Head Rail – review the instructions pertaining to
valance clips below.
Step 4. Install Valance Clips and Valance
For inside mounts - attach the clips to the head rail before inserting
the head rail into the brackets – position them evenly across
the head rail and be sure that the clips do not interfere with the
mechanisms inside the head rail – after inserting the head rail into
the brackets (see below), hold the valance such that the bottom arm
of each valance clip is inside the bottom of the top slot of the valance,
and then gently push up and back to snap the valance into place –
always use the top slot for an inside mount; however, note that the Top
and Bottom of the Valance is a matter of personal preference.
For outside mounts – attach the Valance Returns to the Valance as
illustrated - slide (2) connectors into the mitered end of both returns,
and then attach each return to the valance as shown – snug-up the
corners by hand. Attach the clips to the Valance, and then slide the
clips onto the head rail.
4