Publicidad
Idiomas disponibles
Idiomas disponibles
6. Place the chain o ver and behind the
clutch, fitting the drive l inks i nthe dutch
drum sprocket.
Place chain onto t he sprocket
7. Fit b ottom o fdrive links b etween
the
teeth i nthe sprocket
inthe nose o fthe
guide bar.
8. Fit c hain drive links i ntobar g roove.
9. Pull the bar f orward until the chain i s
snug inthe groove
ofthe bar. E nsure
all
drive l inks a re inthe bar g roove.
10. Hold g uide bar a gainst
the saw frame
and install the c hain b rake.
1I.Replace
the c hain brake nuts and f ighten
finger tight. Once t he chain is tensioned
you will need totighten
chain brake nuts.
CHAIN TENSION (Including
units w ith
chain
already
installed)
NOTE:
When
adjusting
chain
tension,
make
sure the chain brake
nuts are finger
tight only.
Attempting
to tension
the chain
when
the chain
brake
nuts are
tight can
cause damage.
Checking
the tension:
Use the screwd river end of the chain adjust-
ment tool (bar tool) to move the chain around
the bar. If the chain does not rotate, it is too
tight. If too loose, the chain will sag belowthe
bar.
Chain Brake Nuts
Tool (Bar Tool)
Adjusting
the tension:
Chain
tension
is very
important.
Chain
stretches
during use. This is especially
true
during the first few times you use your saw.
Always
check
chain tension
each time you
use and refuel your saw.
An adjusting screw (located on the guide bar)
is used to adjust the tension of the chain (see
illustration).
1. Turn
adjusting
screw
clockwise
until
chain
solidly
contacts
bottom
of guide
bar rail.
Guide bar
Ad2Ur 2i' g
2.
Using the screwdriver
end of the bar tool,
roll chain around guide
bar to ensure all
links are in bar groove.
3.
Lift up tip of guide bar to check
for sag.
Release tip of guide bar, then turn adjus#
ing screw
until sag does not exist.
4.
Tighten bar clamp nuts securely
with the
bar tool.
Chain
Brake t
Nuts
5.
Use the screwdriver
end of the bar tool to
move chain around guide bar.
6.
If chain
does not rotate,
it is too tight.
Slightly
loosen
bar clamp nuts and loos-
en chain by turning
the adjusting
screw.
Retighten
bar clamp nuts.
7.
If chain is too loose, it will sag below the
guide bar. DO NOT operate the saw if the
chain is loose.
,I_WARNING:
If the saw is operated
with a loose chain, the chain could jump off
the guide bar and result in serious
injury.
Publicidad
