Binzel Abicor MT Instructivo De Servicio página 41

MT/AUT/AUT RAB
NOTICE
• Observe the information provided in the following section:
 8 Decommissioning on page EN-16
1 Disconnect the cable assembly from the wire feeder.
2 Remove the parts to be disconnected (change body, bracket, CAT robot mount, torch neck).
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines
must be observed. To correctly dispose of the product, it must first be disassembled.
 11 Disassembly on page EN-20
12.1 Materials
This product is mainly made of metallic materials, which can be melted in steel and iron works
and are thus almost infinitely recyclable. The plastic materials used are labelled in preparation
for their sorting and separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system.
These substances must be stored, transported and disposed of in suitable containers. Please
observe the relevant local regulations and disposal instructions in the safety data sheets
specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags,
etc.) must also be disposed of in accordance with the information provided by the consumables'
manufacturer.
12.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability
to recycle packaging materials is always considered during their selection.
BAL.0193.0 • 2018-07-31
12 Disposal
EN - 21