Parts Identification; Preparation For Use; How To Operate The Thermometer - 180 INNOVATIONS KD-2201 Manual De Instrucciones

Parts Identification

Probe
POWER
Button
LCD Display Battery Cover
What are normal temperature
values?
Human body temperature varies from
person to person and a person's body
temperature can fluctuate throughout the
day. Therefore, it is very important to
know your normal body temperature
range. Thus we recommend measuring
yourself when healthy to establish
reference temperatures which will help
you feel more confident of the measured
temperature when ill.

Preparation for Use

Installing / Replacing the Batteries
1. Pull the battery cover off in the
direction shown.
2. Prior to installing new batteries you
must clean the metal contact ends of
the batteries as well as the metal
springs and contacts in the battery
compartment.
4
Preparation for Use
3. Install 2 new AAA batteries into the
battery compartment being careful to
match the correct polarities.
4. Replace the battery cover securely.
2
1 3
Warning:
1. Do not dispose of batteries in trash.
2. Recycle or manage used batteries
as hazardous waste.
3. Never dispose of batteries in fire.
4. Dispose of used batteries in
recycling trash only.
5. Do not recharge, put in backwards or
disassemble. This may cause
explosion, leakage and injury.
Caution:
1. Replace with 2 new batteries at the
same time.
2. Do not mix alkaline, standard (
carbon-
zinc ) and rechargeable ( nickel-cadmium
batteries and use at the same time.
Always use 'like' batteries.
5
How to Operate the
thermometer
1. Press the POWER button to turn on
the unit. A beep sound follows.
2. The last memory is displayed.
Last memory
3. You will hear 2 beeps and then the
measuring scale as shown in Figure 4
Waiting Ready to test
4. Place the thermometer on the
temple. It will beep one time to
indicate measurement completion.
5. If the temperature reading is over
99.5°F (37.5°C ), eight consecutive
beeps will be heard (fever alarm)
indicating an elevated temperature.
)
6
How to Operate the
thermometer
6. Once the measurement is done, you will
hear 2 beeps indicating the reading has
been recorded and it is ready to take the
next reading. However, we do not
recommend consecutive measurements.
Ready for next
Waiting
measurement
7. Turn off the unit by pressing the
POWER button, or the unit will
automatically turn off after 1 minute
of inactivity.
Switching between Fahrenheit and
Centigrade Scale:
You can switch between °F or °C by pressing
and holding the POWER button again within
3 seconds after turning on the device. The
display will show CH with an °F or °C
℉ mode ℃ Mode
7