CryoPen CT-CT1000 Instrucciones Para El Mantenimiento

Idiomas disponibles

Descargar este manual

INSTRUCTIONS FOR QUARTERLY MAINTENANCE and a POWER OUTAGE

Special Note: Complete this process only if your unit has reached room temperature. Failure to complete this maintenance will result in your unit

not operating properly and could cause the handheld modules to become lodged in place.

1. Turn unit off (Model Shown: CT-CT1000)

3. Using the double sided swab

5. Remove lid and reservoir cup from unit and discard old

solution and refill.

7. Turn unit on. System will be ready for use in

approximately 90 minutes. Test handheld modules (pens) for

readiness using the temperature indicator.

For a Power Surge: Refer to page (4) four of the Operator's Manual. We recommend using a line surge protector to protect your investment.

REFER TO PAGE (8) EIGHT OF THE OPERATOR'S MANUAL FOR ADDITIONAL INFORMATION ON MAINTENANCE.

2. After unit has reached room temperature, approximately 8

hours, remove handheld modules from the chilling wells

4. Remove all reservoir solution and moisture from chilling

wells. Wells should be completely dry.

6. Dry all handheld modules with cotton towel. Place one

full Pipette of reservoir solution in each chilling well. Insert

one pen of choice into each chilling well. Place remaining 3

pens in the holding wells.

Periodically remove side grill and wipe out inside of unit.

Manufactured and Distributed by CryoPen, Inc.

Condensation might be visible.

OM-CT1010-04-R1 revised 07.31.08

Página 1 Special Note: Complete this process only if your unit has reached room temperature. Failure to complete this maintenance will result in your unit not operating properly and could cause the handheld modules to become lodged in place. 1. Turn unit off (Model Shown: CT-CT1000) 2. After unit has reached room temperature, approximately 8 hours, remove handheld modules from the chilling wells 3.
Página 2 Nota especial: Para realizar este proceso, espere hasta que la unidad esté a temperatura ambiente. La falta de este proceso de mantenimiento afectará el funcionamiento de la unidad y provocará que los módulos portátiles se atoren en los orificios. 1. Apague la unidad (modelo de la figura: CT-CT1000) 2. Una vez que la unidad está a temperatura ambiente (ocho horas aproximadamente), quite los módulos portátiles de los orificios de...