none FZ-18DL Manual De Instrucciones página 5

C. SECURING THE PEDESTAL ASSEMBLY TO THE
BASE ASSEMBLY
Align the arrow on the smaller end of rear pedestal with the arrow on
the base assembly (which is near the central hole of the base assembly),
then insert the pedestal assembly into the central hole of the base
assembly. Make sure to align the 3 screw holes on bottom of pedestal
assembly with the 3 holes in the base assembly. ( Fig. 3 )

Secure the base assembly to the pedestal assembly by inserting and
tightening the 3 hand screws into the 3 holes located on the bottom of
the base. ( Fig. 4 )
D. SECURING THE TOWER FAN TO THE PEDESTAL
ASSEMBLY

Carefully turn the fan on its side and place on a table. Back of fan body
is upward. Place the power cord through the center of the pedestal and
base assembly.

Align the arrow on the wider end of rear pedestal with the arrow on the
rear of the tower fan unit and push pedestal assembly close to the tower
fan unit tightly (Fig.5).Firmly hold the fan body steady and rotate the
pedestal assembly clockwise until align the screw hole on the wider end
of the pedestal assembly with the screw hole on the rear of the tower
fan unit(Fig.6).

Inserting and tightening 1 hand screw into the screw hole to secure the
pedestal to the tower fan(Fig.7).
E. SECURING THE POWER CORD TO THE BASE
ASSEMBLY
With the fan still on its side, locate the cord holding bracket on the
bottom of the base assembly. Gently pull any slack out of the power
cord, place the power cord securely in the holding bracket and secure
the power cord bracket over the power cord. Then thread the power
cord through the "U" locating notch at the edge of the base assembly.
( Fig. 8)
Return the tower fan to its upright position.
NOTE: DO NOT OPERATE THE TOWER FAN UNLESS IT IS IN ITS PROPER,
UPRIGHT POSITION.
5
Fig. 3
Screw holes
Fig. 4
Hand screws
Fig. 5
Fig. 6
Fig. 7
Hand screw
Fig. 8