Sonia Maia H5050 Manual De Instrucciones página 9

probe is selected.
• Wave type selection: use the
select the type of probe.
- When the indicator lights up, the type of
wave selected is continuous.
- When the indicator lights up, the type of
wave selected is discontinuous.
- When the indicator lights up, the type of
wave selected is pulse.
• Use the button to start or stop the device.
- When in operation, the Start/Stop indicator
will light up green.
- When paused or in standby mode, the Start/
Stop indicator will light up red.
- Operation
• The unit must be in standby mode with the
Start/Stop indicator lit up red.
• Thoroughly clean the area of skin to be treated
with the appropriate product according to skin
type and remove any remaining product which
may prevent it from penetrating again when
applying the ultrasound treatment.
• Apply conductive gel across the whole area to
be treated.
• Select the probe to be used (face or eyes), the
operating time and set the power to minimum.
• Hold the hand-piece of the ultrasonic probe
with your hand and press
indicator will light up green.
• Massage the area to be treated with small
circular movements for the previously selected
treatment time, setting the desired power.
Bear in mind
• Never use on dry skin. Always apply enough
conductive gel for the entire treatment time.
• The treatment time should never be longer than
15 minutes and the power used should not be
too high. Set the time and power according to
the area of skin to be treated.
● Skin exfoliator function
- Power and configuration
• In standby mode, press
scrubber function. The indicator
light up green and on the control panel:
- The timer will show 15 minutes.
- The power indicator will show 1.
- The continuous wave indicator
up.
- The run / stop indicator will light red on the
push button
button to
. The Start / Stop
Bear in mind
● High-frequency function
to select the skin
will
will light
• Set the timer using the
choose the operating time of the machine, in a
range of between 1 and 30 minutes.
• Set the power using the
choose the power of the machine, in a range of
between 1 and 9.
• Wave type selection: use the
select the type of probe.
- When the indicator lights up, the type of
wave selected is continuous.
- When the indicator lights up, the type of
wave selected is discontinuous.
- When the indicator lights up, the type of
wave selected is pulse.
• Use the button to start or stop the device.
- When in operation, the Start/Stop indicator
will light up green.
- When paused or in standby mode, the Start/
Stop indicator will light up red.
- Operation
• The unit must be in standby mode with the
Start/Stop indicator lit up red.
• Soften the skin in the area to be treated using a
sprayer or clean water.
• Select the type of wave to be used, the
operating time and set the power to minimum.
• Hold the spatula with your hand and press
The Start / Stop indicator will light up green.
• Then gradually set the power to the level
required for the treatment.
• Do not use the skin scraper spatula for a long
time, especially in the case of sensitive skin.
• Control the force you use with the spatula when
scraping. Use at a 45-degree angle to the skin.
• Remember to keep applying product to the
skin to keep it moisturised while performing a
surface massage.
- Power and configuration
• In standby mode, press
frequency function. The indicator
light up green and on the control panel:
- The timer will show 15 minutes.
- The power indicator will show 1.
- The run / stop indicator will light red on the
push button
• Set the timer using the
choose the operating time of the machine, in a
range of between 1 and 30 minutes.
or buttons to
or buttons to
button to
.
to select the high-
will
or buttons to
EN
9