Operating Instructions; Bringing Into Operation; Operation; Time Setting - Premier1Supplies Automatic Poultry Door Indstrucciones De Uso

E . OPERATING INSTRUCTION

1 . Bringing into operation

Danger!
Risk of physical injury and material damage if used incorrectly!
• Installations on the mains network (110v outlet) must only be carried out by qualified electricians.
• Route the electrical cable to the automatic chicken door with protection so that the animals are unable to reach it.
• If the device is supplied with power from the power pack, the battery is not used. However, you should replace the battery at regular intervals. Otherwise
there is a risk that the battery may leak. Spent batteries and the device itself should be disposed of properly without delay.
• Close the housing before connecting the mains plug to the socket! Always disconnect the mains plug from the socket if you are opening
the housing (for example also if you want to insert the light sensor).
Warning
To supply the device with the power it requires, connect either the power pack to the device and
plug it into a mains socket or insert the battery into the device. You can also choose both supply
methods to be prepared for a power failure. The batteries are already installed inside the device.
Connect battery connection wires to the corresponding plug.
Open and close the door a few times to ensure it is operating smoothly. You can now make the
relevant settings, as described below.

2 . Operation

2 .1 Time setting

To set the current date and time, press the OK button for 3-4 seconds. The current (set) year starts
to flash. Change the value using the arrow buttons and confirm the year setting with the OK
button. The date then flashes with the month and day.
Change the value of the date using the arrow buttons. The example shown is 8th of June.
The next confirmation takes you to the setting for the current time.
Change the value of the time using the arrow buttons. Exit the Settings menu with the Menu button.
2 .2 Automatic opening and closing with the timer switch
You can set an opening and closing time for week days (Monday - Friday) and weekends
(Saturday + Sunday). Please note that the door will
only open or close at the specified times if automatic mode is active.
2 .2 .1 Setting the opening and closing times
To set the times, press the Menu button for 3-4 seconds. The opening time for the weekday
setting appears. The opening time is indicated by the
display. Use the arrow buttons to select your desired opening time and confirm the input with
the OK button.
The closing time for weekdays setting then appears. The closing time is indicated by
the symbol on the right side of the display. Use the arrow buttons to select your desired
closing time and confirm the input with the OK button.
The weekend opening time setting appears, followed by the weekend closing time setting.
The times for the weekend can be identified by a dot at the end of the time.
symbol on the right side of the
7
Month Day