Maintenance + Care; Service + Support - AQUAJOE SJI-TLS18 Manual De Instrucciones

Maintenance + Care

Follow the steps below if the sprinkler stops working or
exhibits poor water quality due to debris or dirt build-up.
1. Remove the inlet filter from the hose-end of the oscillator
and run under water (Fig. 6).
Fig. 6
hose-end
2. Remove the cleaning pin from the opposite end of the
oscillator (Fig. 7).
Fig. 7
cleaning
pin
3. To flush, connect the oscillator to a spigot. Turn on the
faucet and while the water continues running, spin the
tube gently back and forth for few minutes. Then screw
the inlet filter firmly back in place (Fig. 8)
Fig. 8
hose-end
inlet filter
inlet
filter
tube
4. Use the provided cleaning pin to clear any clogs from the
spray nozzles. Fit cleaning pin firmly back in place before
using the sprinkler (Fig. 9).
Fig. 9
Storage
Drain the sprinkler after use. DO NOT allow water to freeze in
the sprinkler (Fig. 10).
Fig. 10

Service + Support

If your Aqua Joe SJI-TLS18 oscillating sprinkler requires
®
service or maintenance, please call Snow Joe
customer service at 1-866-SNOWJOE (1-866-766-9563) for
assistance.
Model + Serial Numbers
When contacting the company or arranging service from an
authorized dealer, you will need to provide the model and serial
numbers, which can be found on the decal located on the
sprinkler. Copy these numbers into the space provided below.
Record the following numbers from the housing or handle of your
new product:
Model #:
S J I - T L S 1 8
Serial #:
3
cleaning pin
+ Sun Joe
® ®