Fcc Statement - 7LS ReMOVE MICRODERMABRASION+ Manual De Instrucciones E Información Sobre La Garantia

T R O U B L E S H O O T I N G
PROBLEM POSSIBLE CAUSE
• Unit is not charged
Unit will not operate
• Unit needs to cool down as
indicated by a flashing blue
LED
Cooling surface will not • Cooling button not pressed
operate
• Unit is not fully charged
Unit seems to be losing
suction
• Black wool filter needs to
be replaced
• Diamond tip is not securely
installed
Diamond tip no longer • The diamond tip has an
seems rough accumulation of skin cells
F A Q
H O W O F T E N S H O U L D I U S E T H E P R O D U C T ?
It's best to start slowly – usually just once a week. Then build up to 2 or 3 times a week
if comfortable for your skin.
W I L L I T H U R T ?
No. Treatment should not be painful. Depending on the sensitivity of your skin, you may
feel slight discomfort from the diamond tip as it moves across the skin. There could
be some short-term redness or sensitivity after treatment, but this will soon subside. If
treatment is uncomfortable, you may need to use a lower power setting or switch to
the sensitive diamond tip. The cooling surface will help soothe the skin post-treatment.
10
SOLUTION
• Charge the unit, placing firmly into
the charging base
• Press and hold the power button
for 1 second to turn the power on
• Check circuits, fuses. Try a different
outlet
• Let product sit for an hour prior to
reuse
• Press the cooling button for
1 second. A blue LED will glow
indicating the cooling surface is on
• Charge the unit, placing it firmly
into the charging base
• Replace the filter
• Make sure the diamond tip is
secured tightly to the unit
• Clean the debris from the diamond
tip using the included brush
• Deep clean the diamond tips in an
ultrasonic cleaner (i.e., a jewelry
cleaner) to remove excess skin cell
buildup
C A N I U S E T H E P R O D U C T I N C O M B I N A T I O N W I T H
A N T I - A G I N G C R E A M S / S E R U M S ?
If your anti-aging cream or serum contains AHA (or acid), then it should not be used on
the same day as the microdermabrasion treatment, but can be used on non-treatment
days. Non-AHA (acid free) anti-aging products can be used at any time.
F C C S T A T E M E N T
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules and CAN ICES-3 (B)/NMB-3 (B).
These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
11