The filter holder as well as the glass coffeepot can be washed in a dishwasher.
► Do not clean the appliance when hot.
► Never put the appliance in water or under running water.
► Be sure to unplug this appliance before cleaning. To protect against electrical
shock do not immerse cord, plug or unit in water or liquid.
13.11
Scale removal
Descale your coffee maker every 40 cycles.
You can use:
• either a sachet of scale remover diluted in 2 big cups of water.
• or 2 big cups of spirit vinegar.
Pour the descaler into the tank and turn on the coffee maker (without coffee).
Let the equivalent of one cup of liquid drip into the coffeepot, then stop the appliance.
Allow the unit to stand for about one hour.
Turn the coffee maker back on to complete the dripping.
Rinse out the coffee maker by operating it 2 or 3 times with 1 litre of water.
The guarantee excludes coffee makers which have stopped working or do not
work properly due to lack of descaling.
14 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
► Only qualified electricians, who have been trained by the manufacturer, may carry
out any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
14.1 Causes and rectification of faults
Problem
Coffee brews too slowly (more than
10 minutes)
Filter holder does not fit into the filter
holder attachment properly.
The lid does not close properly.
caso
Warning
Attention
Possible solution
Descale the device (see chapter descaling)
Clean the filter holder attachment and drip stop valve (at
the bottom of the filter holder) of coffee residue.
Place the filter holder in the filter holder attachment so that
the handle is at position "open".
Press it down and turn until it locks into place at position
"close".
40