Fcc Statement - Etouches T1023 Manual De Instrucciones

To Charge T1023
1. Insert the micro USB output of the charging cable into the T1023 & connect USB output to a wall
adapter (not included).
2. LED will light RED while charging & will change to BLUE light once device is fully charged.
To charge electronic devices using the T1023
1. For devices charged by micro USB: use charging cable provided. Insert USB output into T1023 &
micro USB output into your electronic device.
2. For devices charged by 30pin or 8pin (or other): use the charging cable that came with your device.
Insert USB output into T1023 & compatible output into your electronic device.
3. To stop charging, disconnect the charging cable
NOTE: To activate white LED flashlight, press the ON/OFF button.
CAUTION:
Risk of Fire and Burns, don't open, crush, disassemble and dispose of in fire. Accessible surfaces held or
touched for short periods only. Don't heat above 50 °C or Incinerate. Follow Manufacturer's Instructions

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.