Hanging The Fan - Minka Aire Light Wave Manual De Instrucciones De Instalación

HANGING THE FAN

Installing the down rod
Remove the rock pin (2) and hitch pin (1) from the coupling (9) of the motor housing assembly.
(Fig.4)
Loosen the set screws (3) from the coupling (9).
Remove the ball joint (4) and cross pin (5) from the down rod (7) assembly by loosening the set
screw (6). Carefully feed the fan wires (8) through the down rod (7), then thread the rod into the
coupling.
Line up holes and reinstall the rock pin (2) and hitch pin (1). Finally re-tighten the set screws (3).
Fig. 4
Slide the coupling cover (8), canopy cap (6) and canopy
(5) onto the downrod (7). (Fig. 5)
Reinstall the ball joint and cross pin (4) on to the down
rod (7). Make sure that the cross pin is in the correct
position and the ball joint set screw is tightened.
Fig. 5
Fig. 5
Lift the fan assembly onto the mounting bracket. Ensure the registration slot of the hanger ball is
positioned on the stopper of the mounting bracket to prevent the fan from rotating when in
operation. (Fig.6)
Fig. 6
6