Publicidad
Idiomas disponibles
Idiomas disponibles
Coverstitch Binder
/
" (10mm)
3
8
D.
E.
68002291A ©2015 KSIN Luxembourg II, S. àr.l. HUSKYLOCK, COVERLOCK, INSPIRA, SINGER and PFAFF are trademarks of KSIN Luxembourg II, S. àr. l. HUSQVARNA is a trademark of Husqvarna AB.
All rights reserved. Printed in Taiwan on environmentally friendly paper.
Place the fabric strip in the metal guide as illustrated. Slide
4.
the fabric strip into the binder with the wrong side facing you
using tweezers as in illustration. (Illustration D)
5.
When the fabric is through the end of the binder, hold the
folded strip with your left hand and continue to feed
it into the binder as shown. (Illustrations E, F, G)
F.
Raise the presser foot and pull the strip under the foot and
6.
straight back 1-2" (2-3cm) behind the needle. Lower the
presser foot and turn the handweel to make a few stitches to
secure the stitching in the fabric. (Illustration H)
Slide the fabric to be bound right side up into the slot of the
7.
binder, using tweezers if necessary. Sew a few stitches to see
H.
if the coverstitch is in desired position. To change the stitch
position, loosen the thumb screws and move the binder right
or left to reach the desired needle position. (Illustration I) Test
sew a sample before sewing your project.
Tip! Increase the stitch length up to 4.0 if you have heavier
fabric or when crossing a seam.
I.
G.
4
Publicidad
