u FASTENER SPECIFICATIONS u
WARNING! u NEVER USE NAILS OR UNSPECIFIED FASTENERS
to Anchor the Safety Boot - Different Types of Subfloor Material Require Different
Types of Fasteners In Order to Exceed the 200 lb. OSHA Guardrail Requirement
FASTENER SPECIFICATIONS FOR VARIOUS TYPES OF SUBFLOOR MATERIAL APPLICATIONS
SOLID 2X WOOD APPLICATIONS
for solid wood applications use:
4 - Hex-Head Lag Screws,
u
and;
4 -
X 1-
Inch Fender Washers
u
⅜
½
(Fender Washers supplied with all orders)
u Anchor directly into solid 2X lumber using the four
primary corner holes.
PLYWOOD (LESS THAN 1-
OR OSB APPLICATIONS
for plywood (less than 1-
4 - Hex-Head Lag Screws,
u
and;
4 -
X 1-
Inch Fender Washers
u
⅜
½
(Fender Washers supplied with all orders)
u Anchor through the plywood or OSB into floor joists or
solid 2X lumber blocking on the underside of subfloor
using the four primary corner holes.
FOR OTHER SUBFLOORING APPLICATIONS
Always verify through a professional engineer that the subflooring
material as well as the fasteners used to secure the Safety Boot will
support the required load as needed for your specific applications.
Use the Supplied Drill Adapter with a Power Drill and Socket for Fast and Easy Installation
®
X 2 inch
⅜
INCH THICK)
⅛
inch thick) or OSB applications use:
⅛
X 3 inch
⅜
STURD-I-FLOOR
(1-
®
for Sturd-I-Floor
(1-
®
⅛
5 - Hex-Head Lag Screws,
u
and;
5 -
X 1-
Inch Fender Washers
u
⅜
½
(Fender Washers supplied with all orders)
u Anchor directly into Sturd-I-Floor
plywood using the four primary corner holes and by
adding a 5th screw on the inside of the guardrail or
stair rail system in the secondary hole provided.
CONCRETE APPLICATIONS
for concrete applications use:
4 - Common Masonry Fasteners or Similar Concrete
u
Anchors and;
4 -
X 1-
Inch Fender Washers
u
⅜
½
(Fender Washers supplied with all orders)
u Anchor using the four primary corner holes.
IMPORTANT:
Due to the variances in concrete mixtures and applications (such
as, concrete mixture type, psi strength, slab thickness, cure time, etc.), concrete
fasteners used to secure the Safety Boot
basis by a qualified competent person. They should verify that the selected fastener
specifications for average ultimate pullout and shear values are in compliance with
the OSHA required strength
standards.*
include a product specification chart that denotes the average ultimate pullout and
shear values in concrete and/or hollow block applications.
* OSHA STANDARD 1926.502(b)(3):
Guardrail systems shall be capable of withstanding, without failure, a force of at
least 200 pounds (890 N) applied within 2 inches (5.1 cm) of the top edge, in any
outward or downward direction, at any point along the top edge.
INCH THICK) PLYWOOD
⅛
inch thick) plywood applications use:
X 2 inch
⅜
(1-
inch thick)
®
⅛
MUST
be evaluated on a case by case
Most concrete fasteners are packaged to