Neogen PRIMA-SHOT Manual De Instrucciones página 3

SAFETY COVER
METAL
PLASTIC
NEEDLE NUT
NEEDLE NUT
SAFETY COVER
SAFETY COVER
ADJUSTER DIAL
PLASTIC
NEEDLE NUT
SAFETY COVER
ADJUSTER DIAL
twist off, exposing the needle. Keep the needle cover for a safe needle
removal after use.
To remove the needle, replace the safety cover, and turn the needle
INSTRUCTIONS FOR USE
counter-clockwise. The needle should twist out of the needle nut. Discard
the needle in bio-safe container.
TO FIT NEEDLE WITH METAL LEUR NEEDLE NUT:
1.)For safety, leave protective cover on needle until ready to prime the
TO FIT NEEDLE WITH PLASTIC NEEDLE NUT:
instrument.
1.)For safety, leave protective cover on the needle until ready to prime the
2.)Do not remove the needle nut to mount or dismount the needle.
instrument.
3.)Make sure metal needle nut is finger tight; do not tighten with tools, as
2.)Loosen the plastic needle nut until the nib is below the cut-out "T"-slot
this can cause damage to the threaded tip of the barrel
section as shown.
4.)Push the hub of the needle into the needle nut and turn clockwise until
3.)Insert needle hub into T-slot section and screw needle nut firmly onto the
the needle is tightly secure.
barrel.
5.)When you are ready to prime the instrument, remove the needle cover by
DO NOT TIGHTEN WITH PLIERS OR OTHER TOOLS AS THIS MAY
NEEDLE
HUB
turning clockwise and pulling the cover at the same time. The cover will
CAUSE DAMAGE TO THE BARREL.
NEEDLE
twist off, exposing the needle. Keep the needle cover for a safe needle
HUB
4.)Remove the safety cover when ready to prime the Repeater by twisting
removal after use.
the safety cover clockwise and pulling at the same time. The safety cover
To remove the needle, replace the safety cover, and turn the needle
will twist off, exposing the needle.
counter-clockwise. The needle should twist out of the needle nut. Discard
5.)To remove the needle, replace the safety cover back on to the needle.
the needle in bio-safe container.
Partially unscrew the needle nut until the needle can be removed. Discard
the needle in bio-safe container.
TO FIT NEEDLE WITH PLASTIC NEEDLE NUT:
1.)For safety, leave protective cover on the needle until ready to prime the
instrument.
2.)Loosen the plastic needle nut until the nib is below the cut-out "T"-slot
1.)For safety, leave protective cover on the needle until ready to prime the
section as shown.
instrument.
3.)Insert needle hub into T-slot section and screw needle nut firmly onto the
2.)Rotate the Adjuster Dial so that the desired dosage size in ml's is aligned
barrel.
with arrow.
DO NOT TIGHTEN WITH PLIERS OR OTHER TOOLS AS THIS MAY
*Setting the dosage amount can be done at any time except while
CAUSE DAMAGE TO THE BARREL.
NEEDLE
administering an injection.*
HUB
4.)Remove the safety cover when ready to prime the Repeater by twisting
the safety cover clockwise and pulling at the same time. The safety cover
will twist off, exposing the needle.
5.)To remove the needle, replace the safety cover back on to the needle.
Partially unscrew the needle nut until the needle can be removed. Discard
the needle in bio-safe container.
1.)For safety, leave protective cover on the needle until ready to prime the
instrument.
2.)Rotate the Adjuster Dial so that the desired dosage size in ml's is aligned
with arrow.
*Setting the dosage amount can be done at any time except while
administering an injection.*
TO SET DOSAGE:
TO SET DOSAGE:
1-ENGLISH