Dell Networking C1048P Guía De Introducción página 28

• pe-id is a port-extender ID number from 0 to 255. You must enter a
pe-id value; there is no default.
3. (Optional) Provision a C1048P for port-extender stacking.
PORT-EXTENDER CONFIGURATION mode
Dell(conf-pe-0)# stack-unit unit-id type unit-type
• unit-id is a stack-unit ID number from 0 to 7. The default value is 0.
• unit-type is a stack-unit type. The only supported value is C1048P.
4. Provisioning a C1048P automatically creates a LAG (port channel) on the
C9010. The C9010 LAG member ports are the cascade ports configured
for the PE with the cascade interface command. The cascade ports
must be operationally up (no shutdown command) and have a default
port configuration with no L2 and L3 configuration. The port interfaces
must be the same type. You can configure up to eight C9010 ports in the
auto-LAG. The generated auto-LAG number is from 257 to 384.
PORT-EXTENDER CONFIGURATION mode
Dell(conf-pe-0)# cascade interface interface-type slot/
port-range [peer]
• interface interface-type specifies a C9010 10-Gigabit Ethernet
interface. The only supported value is TenGigabitEthernet slot/
port-range .
• slot/port-range specifies a C9010 10GbE port, including slot
number and either a single port number, a port range, or a
combination of both for auto-LAG configuration.
• The range of slot numbers is from 0 to 11. In line-card slots 0 to 9, the
range of port numbers is from 0 to 23; in RPM slots 10 and 11, the
range of port numbers is from 0 to 3.
• Enter a port range with or without spaces; for example, cascade
interface tengigabitethernet 0/1-5 or cascade
interface tengigabitethernet 0/1 - 5.
• You can enter up to six comma-separated ranges or port numbers;
for example, cascade interface tengigabitethernet
0/1-2,8,10–12,15.
• For dual homing, enter peer to specify cascade ports on a peer
C9010.
5. Verify the provisioned configuration on a C1048P.
EXEC Privilege mode
Dell# show pe brief
Dell# show pe pe-id
26