Sockets Panel; Accessory; Rc18 Remote Control; Maintenance - voestalpine Böhler URANOS 1500 Instrucciones De Uso

3.4 Sockets panel

1 Negative power socket
For connection of earth cable in electrode welding or
torch in TIG.
2 Positive power socket
For connection of electrode torch in MMA or earth
cable in TIG.

4 ACCESSORY

4.1

RC18 remote control

This remote control unit allows to ,change linearly the ouput
current without interrupting the welding process.
Operation of the remote control is activated when connected to
the power sources. This connection can be made also with the
system powered on.

5 MAINTENANCE

Routine maintenance must be carried out on the
system according to the manufacturer's directives.
Any maintenance operation must be performed by qualified
personnel only.
When the equipment is working, all the access and operating
doors and covers must be closed and locked.
Unauthorized changes to the system are strictly forbidden.
Prevent conductive dust from accumulating near the louvers
and over them.
Disconnect the power supply before every opera-
tion!
Carry out the following periodic controls on the
power source:
- Clean the power source inside by means of low-
pressure compressed air and soft bristel brushes.
- Check the electric connections and all the con-
nection cables.
22
For the maintenance or replacement of torch component,
electrode holder and/or earth cables:
Check the temperature of the component and
make sure that they are not overheated.
Always use gloves in compliance with the safety
standards.
Use suitable wrenches and tools.
Missing the above named maintenance will invalidate all
warranties and exempt the manufacturer from all liability.

6 TROUBLESHOOTING

The repair or replacement of any parts in the
system must be carried out only by qualified
personnel.
The repair or replacement of any parts in the system by
authorized personnel shall cause the product warranty to
become null and void.
The system must not be modified in any way.
The manufacturer declines any responsibility in case the user
not follow these instructions.
The system fails to come on (green LED off)
Cause No mains voltage at the socket.
Solution Check and repair the electrical system as needed.
By use qualified personnel only.
Cause Faulty plug or cable.
Solution Replace the faulty component.
Contact the nearest service centre to have the sys-
tem repaired.
Cause Line fuse blown.
Solution Replace the faulty component.
Cause Faulty main switch.
Solution Replace the faulty component.
Contact the nearest service centre to have the sys-
tem repaired.
Cause Faulty electronics.
Solution Contact the nearest service centre to have the sys-
tem repaired.
No output power (the system does not weld)
Cause The system has overheated (thermal alarm - yellow
LED on).
Solution Wait for the system to cool down without switching
it off (yellow LED off).
Cause Incorrect ground connection.
Solution Ground the system correctly.
Read the paragraph "Installation".
Cause Faulty electronics.
Solution Contact the nearest service centre to have the sys-
tem repaired.