Installation Method - Yamaha YTS-V1100 Manual De Instrucciones

Installation Method

1. Turn your rack (YRS-1000 or YRS-2000) over so
it's face down.
It is a good idea to spread a blanket or other soft
material on the floor so neither the floor nor the
rack gets scratched.
Be careful when turning the rack over that it does
not get scratched and you prevent injuries.
Before turning the rack over, remove the shelves and top glass
Caution panel from the rack. They might otherwise come out when you
turn the rack over, resulting in damage and/or injury.
Back
Bottom
Blanket or
other soft cloth
3. Stand the rack up and attach the TV mounting bracket to the support column with the four TV mounting
bracket screws C (M5 x 20).
(1) Temporarily screw the two screws halfway in at whichever TV
mounting height you prefer.
(2) Hang the T V mounting bracket on the screws from (1) by its
mounting holes.
(3) Tighten each of the two screws securely.
(4) Tighten the screws that were initially screwed in halfway in step (1).
Top
Middle
Bottom
Be careful when standing the rack up that it does
Caution
not get scratched and that you prevent injuries.
Be sure to tighten the screws that fasten the TV mounting bracket to
the support column. Failure to tighten them properly may cause the
Warning
TV mounting bracket to fall off or break, resulting in injury.
To complete the installation you will need a Phillips screwdriver.
2. Mount the support column on the rack with (1) two
support column mounting screws A (M6 x 16) and (2)
two support column mounting screws B (M6 x 35), in
that order. Attach the auxiliary support with (3) three
auxiliary support mounting screws (M5 x 12).
Auxiliary support
You can select from among three heights for the TV
mounting bracket at 100 mm intervals.
*Some TVs may hit the top panel of the rack, so check
the usable height prior to installation.
Hole
4 En
Auxiliary support
mounting screws E
Bottom
Support column
mounting screws A
Be sure to tighten the screws that fasten the support column to the rack.
Warning
Failure to tighten them properly may cause the support column to tip
over or break, resulting in injury.
If you perform this installation without the auxiliary support installed, the
Warning
stand may tip over, resulting in injury.
Be sure to install the auxiliary support prior to performing the installation.
At bottom height At middle height
Install the TV mounting bracket at a height so that the TV
Caution
does not touch the top panel when the TV is mounted. If the
TV touches the panel, it may cause damage to the TV, the
rack or mounting hardware, or cause injury.
Support column
mounting screws B
Support column
Back
At top height