Troubleshooting; Maintenance And Care - GloGlobe EHF10231 Manual De Instrucciones

Problem
Remote
control is not
functioning.
Water is
inside of
GloGlobe™.
GloGlobe™
turns off too
quickly.

DO NOT fully submerge into water.

Always turn off after each use.

Store indoors when not in use.

Store out of the reach of children.

Clean with soap and water.

Troubleshooting


The small plastic sheet on battery cover remote control
was not removed. Remove it to activate the remote.

The battery of the remote control is dead. Remove it and
replace with a new one. Note the polarity of the battery
on the cover and direction when installing the new
battery in the remote control.

Carefully remove all screws and washers (PHOTO 3).
Set aside in a safe place.

Remove LED module (PHOTO 3) from outer housing.
DO NOT OPEN LED module.

Drain all water from outer housing. Wipe inside of
®
GloGlobe
and outside of LED module dry with cloth.

When reinstalling LED module, tighten the screw
opposite the last one tightened in a criss-cross pattern.

Do not fully tighten screws until all are partially installed.

Screws should be tightened with a maximum torque of
2.65 lbs./1.2 kgs.

Reduce brightness. Operation time depends on the
setting being used. Full brightness will cause operation
time to decrease.

Fully charge GloGlobe
turn green when GloGlobe

Operation time slowly degrades with each use which is
standard for lithium-ion batteries.

Maintenance and Care

Solution
3
5
2
4
®
before using. Indicator light will
®
is fully charged.
7
1
6