Content; General Description Of The Device; Turn On And Off The Device; Standby - Science4you Tab4you V Manual De Usuario

EN
1. Let's start!

1.1. Content

Confirm the contents of your kit:
• Tab4you V
• Micro USB - USB cable
• Electric charger
• User manual

1.2. General description of the device

2
3
4
5
6 7
8
9
Loudspeakers:
audio exit when the headphones
1
aren't connected.
Front* and rear cameras:
2
video-conferences, to record videos and take
photos.
Power ON/OFF/Lock:
3
or 3 seconds to turn on or off the device. When
the device is on, press this button to turn off the
screen (block) or press it again to turn the screen
on.
Headphones port:
4
headphones to listen to multimedia sounds.
Micro USB port: allows connecting your Tab4you
5
V to a computer using a micro USB - USB cable, in
order to transfer data between the two devices. It
also allows charging the battery.
Volume button:
allows adjusting the volume of
6
the device's multimedia. It's possible to raise (+)
or lower (-) the volume of the device.
4
Front camera*
1
cameras to hold
press this button for 2
allows inserting the
Micro SD card slot:
allows inserting a micro SD
7
card, with a capacity up to 32 GB (not included).
Microphone:
allows receiving/recording sounds
8
during videoconferencing or record videos.
Reset:
allows restauring the default definitions
9
of the device. Use a thin object (like the end of a
paper clip) to press the reset button in the hole.
Your devide will shut down. Press the ON/OFF
button to turn it on.
1.3. Turn your device on and off
To turn on your Tab4you V, press and hold the
power ON/OFF/Lock key for 2 seconds, until it's on.
To turn off your Tab4you V, press and hold the
power ON/OFF/Lock key for 2 seconds and then
choose the option 'Power off' .
a) Screen standby mode
To turn on the screen when the device is in
standby mode, you must press the power ON/
OFF/Lock key.
It's possible to set the time, after the home screen
is inactivated, in which the device enters in
suspension. Tap Definitions > Device - Display
> Sleep. Display will turn of and lock after the
defined time of inactivity.

1.4. Lock and unlock the device

Device will enter in standby and the display will
be lock or no activity is registered.
To lock the device press the ON/OFF/LOCK
button.
According to what you have defined earlier you
may need to introduce the defined PIN code