Publicidad
INSTALACIÓN
1. Pass the input cable through the installation
tube, and tighten up the two M10x30 hex
socket screws on it
4. Connect the wires to the terminal block at
right sockets.
MANTENIMIENTO
1. Pull and loosen the two latches at side.
1. Pull and loosen the two latches at side.
2. Pass the input cable through the
rubber gland.
5. Tighten up the two M4x10 cross recessed
pan head screws on the cable clip.
2. Open and remove the upper cover.
2. Open and remove the upper cover.
3. Adjust to the right elevation. Tighten up
the two M10×25 hex socket screws to
fixate the luminary.
6. Close the upper cover and lock it with the
two latches at side. Installation finished.
3. Disconnect the input wire. Undo
the six M4X10 screws at the ends of
the failed driver. Replace the failed
driver with a new one.
3. Disconnect the failed module from driver
at the terminal block. Undo the M4x10
screws on the cable clip .And undo the
M3×6 screws at the ends of the failed
module. Replace the failed module with a
new one.
Conductor y partes eléctricas
4. Connect and tighten up each part
back step by step. Install the upper
cover.
Módulo
4. Connect and tighten up each part
back step by step. Install the upper
cover.
3
Publicidad
