Yamaha PDS-342 Instrucciones Para La Instalación página 5

Attaching to the main unit
1
Insert the support of the pedestal into the
square holes on the bottom of the plasma
display.
Pedestal
3
After connecting the cables, fasten them with wire clamp on the pedestal and accessory
wire clamps sticking on the swivel side of the pedestal necessary.
Caution Avoid any tension to the cables.
Firmly bind the connecting cables to other peripheral products with the wire clamp which is fixed on the swivel side of
the pedestal.
Give an enough slack to the cables from the clamped section to the other products to avoid any tension of the cables
between the plasma display and the other products.
If there is not firmly bound or not enough slack in the cables when the plasma display is turned on the pedestal, a
tension in the cables may be created, which may cause any distortion or breakage of the connecters, or may result in a
heat or a fire at the connection.
Accessory
Wire Clamp
Give an enough slack to the cables.
2
Fix the pedestal stand to the plasma display
using four M6 x 30 screws.
Plasma display
Firmly bind the cables.
3
Wire clamp
M6 x 30 screw (4)
Accessory
Wire Clamp
Swivel Side of
pedestal
Thread the square
hole with the band.
Hook the band
to the claw.