Replacing The Motor; Adjustment Procedures; Replacing The Chain - JARCH 30000 Serie Instrucciones De Operación

Series 30000 Electric Motor Driven Reels

Replacing the motor

CAUTION: Before replacing the motor,
remove all electrical power from motor.
1. Disconnect wiring lines from motor.
2. Remove bolts securing motor mounting
bracket to reel. Remove bracket (refer
to diagram on page3).
3. Install swivel assembly to inlet shaft by
reversing steps 1 and 2. Apply thread
compound to allthreads.
(4) places
(4) places

Replacing the chain

CAUTION: Before replacing the chain,
remove all electrical power from motor.
1. Loosen (do not remove) bolts securing
motor mounting bracket in place.
2. Remove chain master-link.
3. Remove chain master-link. Installnew
chain by reversing steps 1 and 2
above.
https://jarchslipring.en.alibaba.com/

ADJUSTMENT PROCEDURES

Adjusting the reel
1. Adjust reel drag by loosening or
tightening setscrew on hub casting on
manual driven reel.
Adjusting the chain tension
CAUTION: Before adjusting the chain
tension, remove all electrical power from
motor. Over-tensioned (tightening) of
chain results in reduced motor life. Adjust
to allow between 1/4 and 1/2 inch play in
chain.
1. Loosen bolts (do not remove) securing
motor mounting bracket to reel.
2. Move motor mounting bracket and
motor until proper chain tension is
obtained.
3. Tighten motor mounting bracket bolts.
Page 3