REMOVING THE FRONT COVER
The front cover is attached to protect the speaker unit, but
you can remove it if necessary.
The front cover is fixed by magnets. Hold the speaker with
one hand, and pull the front cover gently with the other to
remove it.
Notes:
• When removing the cover, be careful that you don't
touch the drive units, and don't exert excessive
force with any tools.
• There are magnets on the reverse side of the front
cover. Do not place the front cover close to objects
that might be affected by magnets, such as TVs,
clocks, magnetic cards, diskettes etc. after
removing it.
4
E-
SPECIFICATIONS
Type ............................. 2-way bass reflex speaker system
Driver ............................................ 13 cm (5") cone woofer
Impedance ................................................................... 6 Ω
Frequency Response .................. 60 Hz to 50 kHz (-10d B)
Nominal Input Power .................................................. 30 W
Maximum Input Power ............................................. 120 W
Sensitivity .................................................. 89 dB/2.83 V/m
Crossover Frequency ................................................ 3 kHz
Dimensions (WxHxD) ...................... 176 x 323 x 192.6 mm
Weight .............................................. 4.5 kg (9 lbs.14.7 oz.)
• Specifications are subject to change without notice due
to product improvements.
• Care should be taken not to exceed the input power
values noted above.
Magnetic shielding type
3 cm (1") dome tweeter
(6-15/16" x 12-11/16" x 7-9/16")