NORSKE NMAP001 Manual Del Propietário página 4

CUTTING
STRAIGHT CUTTING
Insert material between the cutting blade
and the base, flush with the aluminum
fence (Fig. 4) and hold the material with
foot then push handle down to
complete a cut.
WARNING! Maintain control of the handle.
Do not allow handle to slam back after
making cut.
WARNING! Do not put your fingers against
the sharp edge of the blade at any time.
ANGLE CUTTING
Insert the material between the cutting
blade and the base. Using the markings on
the table top (15*/22.5*/30*/45*), lineup
the board with the appropriate line to get
the desire angle (Fig. 4B). Hold the
material in place with foot then push the
handle down to complete the cut.
WARNING! Maintain control of the handle.
Do not allow handle to slam back after
making cut.
WARNING! Do not put your fingers against
the sharp edge of the blade at any time.
- 4 -
FIGURE 4
FIGURE 4B
WARNING
VERY SHARP BLADE