Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP
Remove the Water Slide from the storage bag. Place the Water Slide on a soft level ground
surface at least 2M from any structure or obstruction such as a fence, garage, house,
overhanging branches, laundry lines or electrical wires.
Check the ground where the Water Slide is to be inflated for any sharp objects or unusual
byproducts. Do not install the Water Slide over concrete, asphalt or any hard surface.
Set up away from any potential fire hazards and keep blower away from water spray and ensure
that water does not spray towards the blower. If water contacts blower, unplug the blower
(air pump) from the power cord. Do not operate until blower is completely dry. Keep the blower
(air pump) and power cord away from water supply and moisture.
Spread out the Water Slide.
Set up as near to power source as possible. After stretching the air fill tube, position the blower
(air pump) at the end of the tube. Slide the end of the tube around the blower (air pump) air
blow sprout and tighten the string. The air fill tube should be straight and untwisted, reposition
the blower (air pump) if necessary. Push ground stakes for air blower through blower base
holes firmly to the lawn ground. (Refer to picture 1)
Locate and attach the sprayer nozzles with Velcro found at the top beam and other designated
area, then secure the hose across the top of the unit and down the sides of the Water Slide with
the Velcro. To avoiding kinking, hose at the bottom part of the Water Slide should be hidden
inside the fabric beam by Velcro. (Refer to picture 2,3)
Attach one end of the hose to the connection which fixed at the end of each cannon.
(Refer to picture 4)
Attach the hose to water supply before turning water on. (Refer to picture 5)
Make sure the blower (air pump) "on/off" switch is in the off position. Ensure the power
connections are safely sited and tripping hazard is minimized.
If the product comes with water bags, like item #9550, please follow the undermentioned
instruction, otherwise, overleap this point. Spread out the product, place and fasten the empty
water bags at the two sides of the product. Open the stopple and fill water in the water bags until
80% full (about 22kg), push and close the stopple. Make sure water bags are firmly attached on
the product and no water leakage before the product is fully inflated, and never allow children to
play on the slide without installing water bags. (Refer to picture 6)
Plug the blower into an approved grounded outlet.
Ensure the blower (air pump) is free from debris and securely sited to avoid tripping.
To inflate the Water Slide, (press the reset botton on GFCI), turn the blower (air pump) "on/off"
switch to on. The continual air-flow blower (air pump) must be left on at all times while the Water
Slide is being used. (Refer to picture 7)
The Water Slide should take less than 2 minute to inflate.
If the product comes with slide extension, like item #9550, please follow the undermentioned
instruction, otherwise, overleap this point. Attach the slide extension to the end of the slide by
velcro, connect the main water hose with the water hose of slide extension, then push the slide
stakes firmly into the ground. (Refer to picture 8,9
Ground support stakes are used for lawn ground surfaces. Hook stakes over loops. To prevent
overturn or lift during play, push stakes firmly into the ground. The stakes should be placed level
with or under the ground in order to reduce tripping hazards. (Refer to picture 11)
If the products comes with the following functions or accessories, please follow the below
correspondence points accordingly, otherwise, overleap the relevant functions points in the
following. Put the correspondence accessories into the product if provided, such as:
Fill the ball pit with plastic balls provided. (Refer to picture 12)
Supply the dart board with dart balls provided. (Refer to picture 13)
You can toss some plastic rings (not provided) to have fun easily. (Refer to picture 14)
You can throw the plastic ball into the net hole to have fun. (Refer to picture 15)
You can play the plastic ball with the basketball hoop to have fun. (Refer to picture 16)
To prevent over turning during play, periodically check that the ground stakes are securely in place.
To anchor the product properly, ALWAYS anchor the product and blower with corresponding ground stakes before use.
Make sure the Slide is inflated fully before children enter to play. Failure to do so will result in the product being unstable and can cause
serious injuries.
Use of this product when under-inflated or during deflation could cause serious injuries. Always check for excessive air loss, and re-inflate
before allowing play to continue.
Turn on the water supply. Thoroughly wet all slide surfaces, platforms, and climbing walls before use to ensure optimal play performance.
As the product remains inflated through constant air flow, air leakage from the seams is normal and necessary so the product does not over
inflate.
If the product comes with support cushions at the sides, do not stand or sit on the cushions. It is drawn user's attention to the orientation of
the inflatable equipment installation in relation to the sun. The sliding surface of the product shall not face to the sun as sun shine can glare
the children's eyes when they are sliding down along the slide.
and 10
)
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Publicidad
Tabla de contenido
