Publicidad
INSTALLATION OF THE COVER
Please make sure to properly install your cover on the structural frame of the Gardenigloo.
Follow all steps as dictated and apply them with two people.
Unfold the cover on a clean, smooth surface as shown in the figure. Keep your cover away from sharp-edged or pointed
objects (sticks, stones), cutting surfaces to prevent damage. If the outside air temperature is below 10°C, keep your cover warm
at room temperature until you are ready to install.
Lay the cover over the frame so
that the zip fastener of the door is
facing inside. Attach the strap on the
tip of the cover to the joint on the
highest point on the frame.
Hold the cover tail of the outer
layer as shown in the figure.
3
2
2
1
1
Pull the marked layers to both
sides equally until they cover exactly
half the total surface area.
Lift the cover tail up and reverse
it by sliding it over the frame.
- 23 -
Open the door zipper from
inside.
Hold the cover tail, gently pull
even and tighten the cover.
Close the zip fastener on the door from the inside. Align
the door and windows of the cover with the frame.
Attach...
... the upper strap of the zip fastener to the joint on top
of the entry opening of the frame.
... the straps to the struts around the windows.
... the straps around the bottom edge of the cover to
the base struts.
See the detailed installation videos at:
http://gardenigloousa.com/pages/video
Publicidad
