Publicidad
Idiomas disponibles
Idiomas disponibles
Before you
start treatment
Testing Your Skin
A small number of people have a skin type which
is more sensitive to the normal level of adhesion
of the LUSTRESTRIPS.
The best way to check whether your skin is more
sensitive is to carry out a short test before your first
treatment.
Attach a LUSTRESTRIP to a LUSTRE ClearSkin device
and place on your inner forearm, just below the elbow.
The LUSTRE ClearSkin treatment head should be
switched on and left in place for at least 20 minutes
before being removed carefully by lifting from one edge.
If there is any discomfort, then we recommend applying
a very small amount of moisturising cream to the skin
before attaching LUSTRESTRIP next time and this will
normally solve the problem. Because of the strength
of the adhesive, with 40 mins sessions, temporary
marks can occur. These marks are only temporary
and will disappear progressively and naturally. Some
skin types may display a temporary darkening which
usually fades in 48 hours.
www.lustreclearskin.com
Charging
LUSTRE ClearSkin
Charging
Connect the supplied charging cable to the LUSTRE
ClearSkin device. Insert the charging cable into a suitable
USB port delivering 5 volts DC at 1 amp maximum.
If using a mains adaptor it is recommended that the
device is charged using an IEC60601-1 compatible
mains adaptor.
The ON/OFF button will turn green when
LUSTRE is fully charged
• LUSTRE will provide three 20 minute treatments
when fully charged
• Do not start the treatment if the ON/OFF button is
red as this signifies the battery needs to be charged
6
www.lustreclearskin.com
7
Publicidad
