Kunft KTE3782 Manual De Instrucciones página 5

• Do not operate the heater with a damaged
cord or plug, or after the heater malfunc-
tions, has been dropped, or damaged in
any manner.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or a similarly qualified person in or-
der to avoid a hazard.
• Use the heater in a well-ventilated area.
Do not insert or allow objects to enter any
ventilation or exhaust opening. To prevent
a fire hazard, do not block air intakes or
exhaust openings in any manner.
• Do not use on soft surfaces, where openin-
gs may become blocked. Use the heater
on flat, dry surfaces only.
• Do not place this heater near flammable
materials, surfaces or substances, as the-
re may be a risk of fire. Keep the above
flammable materials, surfaces or substan-
ces at least 1 m from the front of the pro-
duct and keep them away from the sides
and rear.
• Do not use the heater in any areas where
petrol, paint or other flammable liquids are
stored e.g. garages or workshops.
• Don't use this heater in the immedia-
te surroundings of a bath, a shower or a
swimming pool (600 mm clearance) in an
upright position. Never locate the heater
where it may fall into bathtub or any other
water container.
8
electric radiator 2000W
• Never touch the heater with wet hands.
The heater should be installed so that it
cannot be touched by a person taking a
bath or a shower. (600 mm clearance)
• This heater is hot when in use. To avoid
burns and personal injury, do not let bare
skin make contact with hot surfaces.
• Before moving the heater, please unplug it
and let it cool down for 15 minutes. If pro-
vided, use handles when moving the pro-
duct.
• Please be aware that if other appliances
are in use in the same electrical circuit as
the appliance this can cause an overload.
• The radiator is equipped with a ceramic
heating element.
EN
KTE3782
9