Charging Battery - Trevi SICURO 10 Manual De Usuario

in the package).The card must be placed into the TF slot inside the rear of the phone. Insert
the micro-SD card as below shown, with the golden contacts facing down.Open the metal
shutter by pushing it towards "open", and lock it again after inserting the card by pushing
it in the opposite direction ("lock").
Notes:
• Some card brands may not be compatible with the phone. The use an incompatible
memory may be damaged or the card memory itself.
• The appliance only supports memory formatted in FAT. If you enter formatted cards
differently the phone will ask you to reformat the memory card.
CHARGING THROUGH POWER SUPPLY:
1. Turned off the device, connect the Micro USB plug of the supplied cable to the Micro
USB (7) phone (to use the supplied cable only);
2. Connect the USB outlet on the same power supply cable and plug the latter to a standard
wall outlet;
3. The device will turn on for a few seconds to show the battery icon with it is charging;
4. When the battery is fully charged (the icon is no longer moving), disconnect the power
supply from the wall outlet and then disconnect the plug from the Micro USB phone.
THROUGH RECHARGE "CHARGING BASE" (SUPPLIED):
1. Connect the Micro USB plug of the supplied cable to the Micro USB base (17). Always
use the provided cable, other cable with Micro USB socket could not work with this unit;
2. Connect the USB outlet on the same power supply cable and plug the latter to a standard
wall outlet;
3. Enter the phone turned off inside the base with the keypad facing frontally, the device
will switch on for a few seconds to show the battery icon with charging;
4. When the battery is fully charged (the icon is no longer moving) you can remove the
phone from the base and use it normally.

4. Charging battery

31