Preparation; Required Tools And Material; Prior To Installation; Start-Up - LIVARNO home 14147606L Instrucciones De Montaje, De Uso Y De Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 49
Safety / Preparation / Prior to installation / Start-up
Do not use optical instruments to look at the light.
The lamp's illuminant is not replaceable. The
entire lamp needs to be replaced if the illumi-
nant reaches the end of its service life.
This light is not suitable for dimmer
or electronic switches.
Safe working
Mount the light so that it is protected from
moisture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having difficulty
concentrating or do not feel well.

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference.
The nature of the material is determined by the
individual local conditions.
- Pencil / making tool
- Voltage tester
- Screwdriver
- Electric drill
- Bit (ø approx. 5 mm)
- Side cutting pliers
- Ladder
14 GB/IE

Prior to installation

Important: The electrical connection must be
established by a qualified electrician or a person
trained to perform electrical installations. This per-
son must be familiar with the properties of the light
and the connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 position).
Use the voltage tester to verify the de-energised
status.

Start-up

Mounting the light

Remove the screws
lamp housing
and remove the mounting
5
bracket
at the back.
2
Use the slotted holes in the mounting bracket
intended for the screws to mark the bores.
Now drill the fixing holes (approx. ø 5 mm,
depth approx. 30 mm). Be careful not to
damage the supply line.
Insert the dowels
1
Fasten the mounting bracket
provided screws
4
Open the connection box
two screws on the side of the mains connection
cable (external)
8
Remove the protective tube
mains connection cable (external)
Now use the lustre terminal
connection cable for the light to the mains con-
nection cable (external)
Note: Make sure to correctly connect the
individual conductors of the mains connection
cable (external)
: live wire, black or brown =
8
symbol L, neutral wire, blue = symbol N. The
earth wire (green-yellow) is not connected.
visible at the side of the
3
into the bores.
with the
2
.
by loosening the
9
.
and guide the
7
through it.
8
to connect the
6
.
8
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1414760414147706l14147704l

Tabla de contenido