Troubleshooting; Weee Information - Xiaomi SCWXCQ02ZHM Manual Del Usuario

Specif ications
Cordless Vacuum Cleaner
Model SCWXCQ02ZHM
Dimensions 1208×256×204.5 mm
Battery Nominal
2500 mAh
Capacity
Net Weight 3.5 kg
Dust Compartment
0.5 L (Max)
Capacity
Rated Voltage 25.2 V
Rated Power 400 W
Power Adapter
Model BLJ24W308080P-V
Input 100-240 V ~ 50/60 Hz 0.8 A
Output 30.8V 800 mA
This product contains batteries that can only be replaced by qualified technicians or after-sales service.
This product contains batteries that are non-replaceable.

WEEE Information

All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with
unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated
collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and
recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for
more information about the location as well as terms and conditions of such collection points.
13
So Roller Brushbar
Model 1C-01
Rated Voltage 25.2 V
Rated Power 40 W
Electric Mite Brush
Model 1C-02
Rated Voltage 25.2 V
Rated Power 20 W

Troubleshooting

If the vacuum is not working properly, please refer to the table below.
Errors Possible Causes
Vacuum is out of battery or low on power.
Vacuum does not work Overheat protection mode triggered by a blockage.
Suction opening or airway passage is blocked.
Dust compartment is full and/or HEPA filter
assembly is clogged.
Weak suction force
Attachment is blocked.
Motor makes a strange noise Main suction opening or extension rod is blocked.
The first indicator is red after
Battery is damaged.
turning on the vacuum
The first indicator blinks red
Power adapter is incompatible.
after turning on the vacuum
The adapter is not connected to the vacuum.
The battery is fully charged and went into
Battery indicator does not
sleep mode.
light up while charging
If the problem persists after ruling out the
above two possibilities,
Charges slowly Battery temperature is too low or too high.
Solutions
Fully charge the vacuum, then resume use.
Wait until the vacuum cools down, then reactivate it.
Clear any blockages from suction opening or airway passage.
Empty the dust compartment and clean the HEPA
filter assembly.
Clear any blockages in the attachment.
Clear any blockages in main suction opening or extension rod.
Please contact the after-sales service department for
maintenance.
Only use the original power adapter to charge the vacuum.
Make sure the power adapter is plugged in properly.
Can be used normally.
Please contact the after-sales service department
for maintenance.
Wait until the battery's temperature normalizes,
then resume use.
14