Description Of Parts - Semilac PRO WHITE Manual Del Instrucciones

Only use AC adapters intended for this device. Do not apply voltage
other than indicated on the device. This equipment may be used by
children over 8, persons with limited physical and mental capacity
as well as individuals without any experience or unfamiliar with
the equipment, provided that supervision or instruction concerning
safe use of the equipment is provided in a way ensuring the
understanding of potential dangers. Children should not be allowed
to play with the device. Children should not be allowed to perform
cleaning or maintenance of the device unsupervised.
SEMILAC PRO WHITE ELECTRIC NAIL DRILL
PACKAGE CONTAINS:
Control box
Foot pedal
Instruction manual
Handpiece holder
Handpiece with bit chuck
Power supply cable

DESCRIPTION OF PARTS

1. Control box
2. Speed control knob
3. LED power indicator
4. On/Off button
5. Foot pedal socket
6. Handpiece socket
7. Rotation direction change switch
8. Handpiece holder mount
9. Handpiece holder
10. Power supply cable
11. Power supply cable plug
12. Blank drill bit
13. Handpiece outer ring
14. Handpiece
15. Handpiece cable
16. Foot pedal
17. Foot pedal cable
INSTRUCTION MANUAL
CONTROL BOX: Please read the manual before use. Before use, make sure the device is turned off. Connect the power plug of
the control box to a power source. Plug the handpiece cable to the corresponding socket on the control box. Turn the device on
by pressing the "ON" button – a green power indicator will light up. Select the direction of rotation (F/R – Forward or Reverse).
Only do this when the speed control knob is at „OFF". Turn the speed control knob to achieve the desired speed. After you finish
using the device, turn the speed control knob to „OFF", turn off the device by pressing the „OFF" button, and disconnect the
device from the power source. If the device is idle for a longer period, disconnect the cable from the power source. After each
use, clean the device of dust.
FOOT PEDAL: Connect the foot pedal cable to the corresponding socket on the back of the control box. To start the device, push
4 EN