Connecting Electrical Power To The Video Splitter - Dometic WAECO PerfectView VS 400 Instrucciones De Montaje Y De Uso

VS400
7 Connecting electrical power to the
video splitter
7.1 General notes on laying cables
NOTE
I
 As far as possible, use original ducts for laying the cables, or
other suitable options such as panelling edges, ventilation
grilles or dummy plugs. If no openings are available, you must
drill holes for the cables. Check beforehand that there is suffi-
cient space on the other side for the drill head to emerge.
 Cables and connections that are not properly installed will
cause malfunctions or damage to components. Correct installa-
tion of cables and connections ensures lasting and trouble-free
operation of the retrofitted components.
Therefore, please observe the following instructions:
 Wherever possible, lay cables inside the vehicle, as they are better pro-
tected there than outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fas-
tened (use additional cable ties, insulating tape etc.).
 To prevent damage to the cables when laying them, ensure that they are
far enough away from hot or moving vehicle components (exhaust pipes,
drive shafts, light systems, fans, heaters, etc.).
 Screw on the plug connections for the connecting cables to protect them
against water penetration (fig. 4, page 4).
 When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3,
page 4).
 Protect every through-hole made in the bodywork against water penetra-
tion, e.g. by using a cable with a sealant and by spraying the cable and
the cable sleeve with sealant.
NOTE
I
Only start sealing through-holes when you have completed all in-
stallation work on the camera and have laid the required cable
lengths.
EN
All manuals and user guides at all-guides.com

Connecting electrical power to the video splitter

31