JAROLIFT TDRCt04 Instrucciones Originales página 18

PROGRAMMING
To set the end positions of the controlled radio drive and for further settings or programming steps, you need the instructions
for the respective radio motor or external radio receiver!
Initial programming TDRCT04
The example shown is exemplary and depends on the respective receiver type. Please refer to the instructions of the receiver!
NOTE: Each key must be pressed (held) for approx. 1 second!
Each programming step must be carried out within approx. 10 seconds.
Otherwise, the system automatically exits the programming mode. If necessary, start from the beginning.
1. On the handheld transmitter, use the K3 button (for a description, see page 5) to select the desired channel on which the
receiver is to be programmed (the active channel is marked by a frame in the lower channel bar).
2. Set the desired radio receiver or radio motor to programming mode according to the associated instructions.
3. Within approx. 10 seconds, press the up and down buttons of the hand-held transmitter simultaneously.
4. Then immediately press the stop button on the hand-held transmitter.
5. Successful teach-in is acknowledged by a short vibration of the tubular motor connected to the radio receiver or the vibrati-
on of the radio motor.
ATTENTION! Programming in the setting "Group control" (several channels are selected) is NOT possible.
is NOT possible!
As an alternative to pressing the up, down and stop buttons, the programming button on the back of the hand-held transmitter can
also be used (option 2 - depending on the model).
Possibility 1:
Select the desired
channel (1-4)
with the K3 to
select.
Possibility 2:
Select the desired
channel (1-4)
with the K3 to
select.
If you want to control more receivers with this transmitter/channel, repeat the procedure.
ATTENTION!
Check the function with the UP/STOP/DOWN buttons on the hand-held transmitter.
If the direction of rotation of the motor is incorrect (roller shutter / motor moves downwards when the UP button is pressed),
the direction of rotation of the motor must be changed.
Please refer to the chapter "Changing the direction of rotation" of the respective radio motor or radio receiver.
18
Set the receiver
to learning mode
according to the
max. 10 sec.
instructions.
Set the receiver
to learning mode
according to the
max. 10 sec.
instructions.
Press the UP/
DOWN key
simultaneously
and then press
STOP.
Briefly press the pro-
(engine vibrates)
gramming button
(back) with a biro or
a small screwdriver.
(engine vibrates)