Tools Required For Assembly; Adjusting The Abrasive Cut-Off Saw; Removing And Installing The Abrasive Cutting Wheel - Kawasaki 691783 Manual De Instrucciones

The 14 in. Cut-off saw comes pre-assembled from the factory and needs no assembly.

TOOLS REQUIRED FOR ASSEMBLY

The tools are supplied by the customer.
It is highly recommended that the 14 in. Cut-off saw be securely mounted to a tool
stand. This is to prevent excessive vibration during use. Mount the Cut-off saw to
the tool stand by:
1. Most tool stands have pre-drilled holes to accommodate a variety of tools.
2. If the tool stand does not have an exact match for the holes, try to align the tool
base with as many pre-drilled holes as possible. Mark and drill new holes for
mounts that have missing holes.
3. Remove the rubber feet screws. Insert three 1/4 in. X 20 screws and washers
through the underside of the tool stand and up through the rubber feet on the
base of the Cut-off saw. The length of the screws should be 1 in. (25mm).
4. Tighten the screws securely.

ADJUSTING THE ABRASIVE CUT-OFF SAW

Disconnect the abrasive Cut-off saw from the AC power
source eliminating any accidental starting of the motor.
ARM RELEASE/LOCK
KNOB
FIGURE 2. UNLOCKING THE CUT-OFF SAW
All manuals and user guides at all-guides.com
TO CARRY THE CUT-OFF SAW:
Fold down arm to base and push in
the arm release to lock.
TO UNLOCK THE CUT-OFF SAW:
To unlock tool and raise arm,
depress arm slightly and pull out
motor arm release. The motor arm
will pivot upward. See Figure 2.
15

REMOVING AND INSTALLING THE ABRASIVE CUTTING WHEEL

To avoid any accidental starting of the cut-off saw,
unplug the saw from the AC power source.
1. Pull out the arm release knob to unlock the saw arm and raise the arm to its
full open position. Then raise and rest the lower guard at its highest position.
2. Push in the arbor shaft lock lever and rotate the abrasive wheel until the arbor
lock engages locking the wheel in place.
3. Hold the arbor shaft lock in place and use the wheel wrench (provided), remove
the arbor hex head screw by turning it counterclockwise. Also, remove the
washer, outer flange and abrasive wheel.
4. Mount the new abrasive wheel securely over the oblong arbor.
ARBOR SHAFT LOCK LEVER
ABRASIVE WHEEL
FIGURE 3. REMOVING/INSTALLING THE CUTTING WHEEL
LOWER GUARD
OUTER FLANGE
WASHER
HEX HEAD
SCREW
WRENCH
16