Tabla de contenido
Publicidad
722310038GBNLFE
Instructions for use - Gebruiksvoorschriften - Consignes de travail -
Consignas per uso
Intend Use
GB
This tool was designed to soldering tin. The soldering temperature can be adjusted according the application.
Technical specification
Rated voltage:
220-240V~
Output voltage to the soldering iron: 24V~
Effect:
48W
Range of temperature setting:
100-450
℃
Temperatures
Melting point: Approx. 215 °C;
Normal use: 215-300 ° C;
Collecting surplus tin from minor soldering: approx. 315 °C;
Collecting surplus tin from extensive soldering: approx. 400 °C;
Production soldering for industry/handicraft: 320-380 °C.
Please note: do not let the soldering station stand idle at a high temperature for long periods of time, since this will
destroy the soldering tip surface.
Operating
1. Place the soldering station on a hard and durable surface where the air circulation is good.
2. Connect the plug to the soldering station outlet.
3. Place the soldering iron stand [1] in a groove in one of the corners of the soldering station.
4. Connect the soldering station power cable to the socket.
5. Turn the soldering station on using the power switch [6]. The display [3] lights up.
6. During warm-up the light [4]"HEATER ON" is lit. It switches off when the set temperature has been reached.
When display "LO", the temperature is lower than 100° C, just leave it heating up.
7. Set the required temperature. turn the adjusting knob [5] (clockwise to increase and anticlockwise to decrease the
temperature setting) until the required value is shown on the display. Temperature range : 100-450 ℃.
8. Wipe off excess tin from the soldering tip onto the slightly dampened sponge [2] before turning the soldering station off.
9. Switch off the soldering station using the power switch after soldering. Disconnect the power cable when the soldering
Version 201308 1.0
Publicidad
Tabla de contenido
