Product Characteristics; Safety Instructions - YATO YG-03006 Manual Original

GB

PRODUCT CHARACTERISTICS

Hand blender is used for food preparation. Due to the mixing attachment, it is possible to prepare food by cutting and mix food
products. If the blender has accessories it is also possible to extend the preparation scope of dishes. Correct, reliable, and safe
operation of the device is dependent on its proper use, therefore:
Prior to working with the product, you should read all the instruction and keep it around.
For any damage caused by failure to comply with safety regulations and instructions of this manual, the supplier is not responsible.
EQUIPMENT
The product is supplied in a complete state but it requires some preparatory steps before starting its operation, described later
in this manual.
The mixing attachment is provided with YG-03006 product.
With the product YG-03006 there are also supplied: mixing attachment, container with the scale, compacting attachment, cutting
attachment along with a container with a lid and a handle, which is allowing to mount the attachments for a storage period.

SAFETY INSTRUCTIONS

Attention! Read all the instructions below. Failure to comply with them can lead to electrical
shock, fi re or personal injury.
FOLLOW THE FOLLOWING INSTRUCTIONS
Do not use the product in an environment with an increased risk of explosion, containing
fl ammable liquids, gases or vapors.
Before you run the product, you should check whether it, its accessories, and the connection
cable are not damaged. If you noticed any damage is prohibited to started operation of the
product. It is forbidden to repair the power supply cable, it should be replaced with a new one.
Any replacement of damaged items including the power cord, should be carried out only in
the authorized facilities, Any independent repair of the product is forbidden.
The product designed for indoors operation only. Do not expose the product to humidity or
precipitation. Water and moisture that gets inside the device increases the risk of electric
shock. Do not immerse the product in water or any other liquid.
Connect the unit only to the mains of voltage and frequency shown on the rating plate of the
device. Power cord plug must fi t into the wall outlet. It is forbidden to modify the plug. Do not
use any adapters in order to adapt the plug to the outlet. The unmodifi ed plug, which fi ts the
outlet, reduces the risk of electric shock.
After each use, you should disconnect the power cord plug from a mains outlet. Always
unplug the blender from the power supply if it is left unattended and before its assembly,
disassembly or cleaning.
Do not overload power cable. Do not use the power cord to carry, plug and unplug the plug
from the mains outlet. Avoid contact of the power cord with heat, oils, sharp edges and mo-
ving parts. Damaged cable increases the risk of an electric shock. In the event of damage to
the power cord (e.g., intersection, melting of insulation) you should immediately disconnect
the plug from the wall outlet, and then pass the product to an authorized repairing service. It is
forbidden to use the product with a damaged hose. It is forbidden to repair the power supply
O R I G I N A L I N S T R U C T I O N S
8