For Your Safety; Tool Specifications; Operating Controls; Use As Intended - Master LS 2 Instrucciones Para El Manejo

LS 2 - book Seite 6 Montag, 16. April 2007 8:05 08
GB
Working safely with the measuring tool is possi-
ble only when the operating instructions and the
safety notes are read completely and the instruc-
tions contained therein are strictly followed. Save
these instructions and hand them over to other persons
before allowing them to operate the device.
This measuring tool uses class 2M laser irradiation in accord-
ance with IEC 60825-1: 2001 and FDA 21 CFR Ch. I §1040:
2004. This can cause you or other persons to be unintention-
ally blinded.
The device meets the requirements for electromagnetic com-
patibility (EMC). Interference of other equipment/devices
within the vicinity of the Laser Distance Meter is not excluded
when these are not sufficiently shielded against radio fre-
quency signals. Observe the safety information of such equip-
ment/devices.
The symbols used have the following meaning:
DANGER:
Operational danger or improper usage that can cause seri-
ous personal injury.
CAUTION:
Operational danger or improper usage that can lead to
minor personal injury, but cause major material damage,
financial loss or environmental damage.
Danger of blinding by the laser beam.
2M
Do not look into the laser beam and do not aim the
beam at other persons or animals.

Tool Specifications

Angle laser
Order number
Measuring range (max.)
Measuring inaccuracy
Battery
Battery operating life
Protection class
Operating temperature
Weight, approx.
6

For Your Safety

DANGER:
Do not look into the laser beam and do not unnecessar-
ily aim the beam at other persons or animals. The natu-
ral corneal reflex is not a sufficient protective measure.
Do not look into the laser beam with optical aids, such
as, e.g., binoculars. Optical aids can focus the laser
beam in a dangerous manner for the eye.
Do not make the type plate on the device unrecognisa-
ble. Missing information of the laser class can lead to
careless handling of the device on behalf of the user.
Keep the device out of the reach of children. They can
cause danger to themselves and to others.
Never open the device yourself. The laser beam is dan-
gerous for the eyes. Have damages repaired only through
an authorized Würth customer service agent.
CAUTION:
Do not drop the device. Perform check measurements
before carrying out important measuring tasks. Pay atten-
tion to cleanness of the laser optics.
Protect the device against moisture. Penetrating moisture
damages the electronics. Always store and transport the
device in its protective case.
Use only original Würth accessories. Usage of accesso-
ries that are not recommended can lead to incorrect
measured values.
For further notes on safety refer to enclosed Sheet.
1 Stop edge
LS 2
2 Spirit levels
0714 640 117
3 Buttons for wall attachment with adherent aid
30 m
4 On/Off switch
± 6 mm over 18 m
5 Levelling dial
3 x AA, 1,5 V
6 Laser beams arranged at 90°
ca. 15 h
7 Openings for adherent aid
IP 55 8 Adherent aid (accessory)
9 Battery compartment
0 ... +40 °C
0,45 kg
Not all of the accessories illustrated or described are included
as standard delivery.
The device is intended for determining and checking right
angles on floors and wall surfaces.
For damage caused by usage other then intended,
the user is responsible.

Operating Controls

Use as Intended