Fellowes POWERSHRED 125Ci Manual Del Usuario página 4

Ocultar thumbs Ver también para POWERSHRED 125Ci:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
AUTO
Turn off and unplug
Locate Auto-start
shredder
infared sensor
OILING SHREDDER
noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
AUTO
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREVENTIVE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
A
B
C
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
All manuals and user guides at all-guides.com
.
4
3
Dip cotton swab in
rubbing alcohol
away any contamination
from the paper sensors
A. Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum
operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will
not operate for the duration of the recovery time. See Basic Shredding Operation for more information
about the continuous operation and recovery time for this shredder.
B. Door Open Indicator: The shredder will not run if the cabinet door is open. When illuminated, close the
D
E
door to resume shredding.
C. Bin Full Indicator:
waste bag 36054.
D. Remove Paper Indicator: When illuminated, press reverse (
E. SafeSense
and the shredder will stop shredding. If SafeSense
turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (125Ci only).
Indicator: If hands are too close to the paper entry, the SafeSense
®
is active for 3 seconds, the shredder will automatically
®
ENGLISH
Models 125Ci/125i
) and remove paper.
®
indicator will illuminate
4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Powershred 125i

Tabla de contenido