Description (Fig. A) - Luna ferax FDS-110 Manual Del Usuario

thickness of 1.5 mm
cable reel, always fully unroll the cable.
Mains plug replacement (Uk only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approved BS 1363/3A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
TECHNICAL DATA
FDS-110
Mains voltage
Mains frequency
Power input
No-load speed
Protection class
Sanding pad dimensions
Weight
NOISE AND VIBRATION
FDS-110
Sound pressure (L )
pa
Acoustic power (L )
wa
Uncertainty (K)
Vibration
Uncertainty (K)
2
Wear hearing protection.
vibration level
The vibration emission level stated in this
instruction manual has been measured in
All manuals and user guides at all-guides.com
. If you use a extension
2
V~ 230
Hz 50
W 110
min 13,000
-1
IP 20
mm 145x145x88
kg 0,8
dB(A) 76.0
dB(A) 87.0
dB(A) 3
m/s 1.24
2
m/s 1.5
2
accordance with a standardised test given in EN
60745; it may be used to compare one tool with
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns

DEsCrIpTION (FIg. A)

Your delta sander has been designed for sanding
wood, metal, plastics and painted surfaces.
1. On/off switch
2. Handle
3. Ventilating apertures
4. Sanding-sole
5. Sandpaper
AssEMBLY
4
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the sanding paper
(fig. B)
Mounting
● Mount sanding paper (5) with the required
grain size onto the sanding pad (4). Make
sure that the perforation in the sanding paper
(5) corresponds with the perforation on the
sanding pad (4).
- Use coarse sanding paper (grain 50) for
sanding rough, uneven surfaces.
- Use medium sanding paper (grain 80) for
removing the remaining scratches from the
coarse sanding paper.
- Use fine sanding paper (grain 120) for
finishing surfaces.
removing
● Remove the sanding paper (5) from the
sanding pad (4).
GB
25