allen+roth 9006BNMV Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
1.
Fasten mounting brackets (BB) to shelf (A) and towel
bar (B) with hex-head screws (AA).
NOTE: Drain holes located on towel bar (B) should
be on the bottom.
2.
Hold the unit at the desired position on the wall.
NOTE: Make sure the unit is level.
Mark mounting points on wall through holes in the
mounting brackets (BB). Hammer wall anchors (CC)
into wall, unless mounting screws (DD) will go directly
into a stud.
NOTE: Do not use a wall anchor if mounting screw
will be going into a stud.
Wall anchors (CC) should be oriented with the flat
side horizontal. Place unit against wall, lining up
holes in wall and holes in mounting brackets (BB).
Complete mounting by tightening mounting screws
(DD) into studs or wall anchors (CC).
All manuals and user guides at all-guides.com
Hardware Used
AA
BB
Hardware Used
CC
DD
3
Fig. 1
AA
Hex-Head Screw
Mounting Bracket
Fig. 2
CC
Wall Anchor
Mounting Screw
A
B
BB
x 4
x 2
BB
DD
x 4
x 4
IS9007-I2