Product Use - Greencut MH202-4 Manual De Instrucciones

PRODUCT USE

BATTERY
ATTENTION: The battery must be charged before the first use.
1. Make sure that the charger you are using is applicable to the battery pack.
2. Insert the charger into a 110-240V~, 50/60Hz power outlet. The indicator light (3) turns green to show that
the power is on.
3. Insert the end of the charger (1) into the battery slot (2). Make sure that the contact with the charger is
correct.
4. During charging, the indicator light (3) illuminates red.
5. When fully charged, the indicator light (3) lights green.
6. Frequently check the charger and battery while they are connected.
7. Unplug the charger and disconnect it from the battery pack when finished.
8. Allow the battery pack to cool completely before use.
9. Store the charger and battery pack indoors, out of the reach of children.
NOTA: If the battery is hot after continuous use in the tool, allow it to cool to room temperature
before charging.
BATTERY CONTROL LIGHTS
There are battery capacity indicators on the battery pack; you can check the battery capacity status by pressing the
button. Before using the machine, press the switch trigger to check if the battery is full to work properly.
Those 3 LEDs can show the battery capacity level status.
BATTERY REMOVAL AND INSERTION
1. Remove the battery: Push the battery release latch inwards and at the same time remove the battery pack.
2. To insert the battery pack, push the battery pack over the contacts of the tool.
53
EN