To Assemble And Disassemble The Cutting Attachment Guard And Trimmer Head - RedMax BCZ350S Manual Del Usuario

WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
page 22 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
To assemble and disassemble the cutting
attachment guard and trimmer head
CAUTION: Make sure that the guard
extension is attached.
1. Attach the correct cutting attachment guard (A) for
the trimmer head. Refer to
2. Put the cutting attachment guard onto the fitting on
the shaft.
3. Attach the cutting attachment guard with the bolt.
4. Install the drive disc (B) on the output shaft.
5. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
6. Put the locking pin (C) in the hole to lock the shaft.
L
M
A
7. Turn the trimmer head /plastic blades (H) in the
opposite direction from which the trimmer head/
plastic blades rotate.
H
1289 - 002 -
Accessories on
Accessories on page 22 .
C
C
M
H
8. To disassemble, follow the instructions in the
opposite sequence.
To attach the grass blade and the grass blade
guard/combination guard
1. Put the blade guard/combination guard (A) onto the
shaft and tighten the bolt to attach it.
2. Make sure that the guard extension is removed.
3. Turn the output shaft to align one of the holes in the
drive disc (B) with the related hole in the gear
housing.
4. Put the locking pin (C) in the hole to lock the shaft.
5. Put the grass blade (D), the support cup (E) and the
support flange (F) on the output shaft.
H
A
L
6. Make sure that the drive disc and support flange
engages correctly in the centre hole of the grass
blade.
7. Attach the nut (G).
A
G
D
C
A
E
F
B
11