Beper 40.490 Manual De Instrucciones página 8

Wall-mounted Hair Dryer Use Instructions
Description of product Fig. A
1. Hair dryer
2. Wall base
3. Plug
Instructions for mounting
To reduce risk electric shock, do not install the appliance next to bath tubs or sinks.
It is important to install the appliance at a proper height, as it is natural for coiled electrical wire to loosen and
stretch with time.
Note: it is strongly recommended to contact qualified personnel for installation, to avoid damages caused by
erroneous mounting of the appliance.
Lay the wall base flat against the wall, and use the holes as a guide to find and mark the desired position for the
installation
Remove the wall base and start drilling where the marks on the wall have been traced; use a drilling tip of 6 mm
or ¼".
Insert the plastic anchors into the holes
Remove the hair dryer from the wall base, and lay the wall base flat on the wall, with holes in correspondence
with the anchors, and insert the screws
Fasten clockwise until the wall base is firmly fixed and steady
Insert the hair dryer into the wall base and plug into the wall socket
Operating instruction
Ensure that the ON/OFF switch is set on 0 before plugging the appliance
To turn the appliance on, remove the hair dryer from the wall base and set the speed on 1 or 2, based on pre-
ference
To suspend the operation of the appliance, insert the hair dryer into the wall base, leaving the ON/OFF switch on
the selected speed position; to resume operation, just remove the hair dryer from the wall base
To turn the appliance off, set the ON/OFF switch on 0
In case of sudden shut down of the appliance, immediately set the ON/OFF switch on 0, and let the hair dryer
cool for a few minutes before using again
Cleaning and maintenance
Before performing any maintenance or cleaning, ensure that the appliance is off and unplugged from the wall
socket. Do not put the appliance in water and ensure that the plug and the power cord are always kept dry.
Use a damp cloth to clean the appliance, and wipe dry thoroughly; do not use solvents or abrasive cleansers or
detergents.
Technical data
Power: 1700-2000W
Input: 220-240V~ 50-60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
8