Cleaning And Maintenance - Beurer Compact MG 99 Instrucciones De Uso

4. The LED for the relevant current battery charge level flashes during the charging process. As
soon as the Deep Tissue Massager is fully charged, all 3 LEDs will light up permanently. The
battery will last for approx. 5 hours of operation when fully charged. If, during operation, the
left LED of the battery charge level display 3 starts to flash, the device must be charged, as
otherwise it will automatically switch off.
5.2 Selecting/changing the attachment
Choose the suitable attachment before you begin massaging.
To change an attachment, proceed as follows:
1. Pull the existing attachment horizontally off the Deep Tissue Massager
2. Slide your desired attachment firmly into the Deep Tissue Massager until you feel it click se-
curely into place
5.3 Switching the device on/selecting the vibration level
Note
The Deep Tissue Massager comes with an automatic switch-off function. This means that the
Deep Tissue Massager automatically switches off after a period of use of 10 minutes.
1. Slide the ON/OFF switch
on the battery charge level display
2. Press the ON/OFF button
play starts to light up. The massage starts at intensity level 1.
1
3. To change between the fi ve intensity levels, briefl y press the ON/OFF button
Intensity level 1:
Intensity level 2:
Intensity level 3:
Intensity level 4:
Intensity level 5:
4. You can switch off the device at any time during use by pressing and holding the ON/OFF
button (approx. 2 seconds). If you press the ON/OFF button
level, the device will switch off. The device is in standby operation.
5. Slide the ON/OFF switch
plication. The device is completely switched off.
Note: If the device stops during application, this may be a result of excessive exertion of
pressure. Therefore, ensure that you do not exert too much pressure while applying the de-
vice.

6. CLEANING AND MAINTENANCE

Cleaning
WARNING
• Switch off the device each time before cleaning.
• Do not clean the device in the dishwasher.
• Only clean the device with a slightly dampened cloth and a non-abrasive detergent. For hygi-
enic cleaning, clean the attachments
agent.
• Clean the device only in the manner indicated. Under no circumstances must any liquid be
allowed to enter the device.
.
C
on the underside of the handle 4 to the "ON" position. The LEDs
6
3
to switch the device on. The left LED of the intensity level dis-
2
approx. 1800 rpm/30 Hz
approx. 2100 rpm/35 Hz
approx. 2400 rpm/40 Hz
approx. 2700 rpm/45 Hz
approx. 3000 rpm/50 Hz
on the underside of the handle
6
will begin to light up.
/ / / with water and a non-abrasive cleaning
7 8 9 10
19
.
B
again on the fifth intensity
2
to the „OFF" position after ap-
4
:
2