Tabla de contenido
Publicidad
6. Oil Pressure (Figure 4-1). Indicates engine oil
pressure. Reference the engine operator's manual
for further information.
7. Hourmeter (Figure 4-1). Indicates the number of
hours the engine has been operated. It operates
whenever the engine is running. Has preset
maintenance reminders for engine and hydraulic
system oil changes. Will start flashing scheduled
maintenance 2 hours before preset time and continue
flashing until 2 hours after. Automatically resets.
8. Fuse Holders (Figure 4-1). There are one 20-amp
fuse and one 50-amp resettable fuse that protect the
mower's electrical system. To replace fuse, pull fuse
out of the socket and install a new fuse.
9. Left Steering Control (Figure 4-1). Used to control
the mower's left wheel when traveling forward or
reverse.
10. Right Steering Control (Figure 4-1). Used to
control the mower's right wheel when traveling
forward or reverse.
11. Parking Brake Control (Figure 4-1). Used to
engage and disengage the parking brakes. Pull the
lever back to engage the parking brakes. Push the
lever forward to disengage the parking brakes.
12. Fuel Tank Gauge (Figure 4-1). Indicates the
amount of fuel in the fuel tank.
13. Dump Valve Control Levers (Figure 4-2). Located
on the hydraulic pumps, used to "free-wheel" the
mower. Rotating the levers clockwise until they stop
allows the unit to move under hydraulic power. The
levers must be in this position and torqued to 10ft/lbs
during operation of the mower. Rotating the levers
counter-clockwise allows the mower to be moved by
hand (free-wheeling).
14. Deck Lift Foot Lever (Figure 4-1). Used to raise
and lower the cutter deck.
15. Cutting Height Adjustment (Figure 4-1). Used to
set the cutter deck at the desired cutting height.
All manuals and user guides at all-guides.com
16. Deck Release Lever (Figure 4-1). Used to lock the
17. Temperature Gauge (Figure 4-1). Indicates the
18. Seat Belt (Figure 4-1). Used to secure the operator.
4.2 SAFETY INTERLOCK SYSTEM
The mower is equipped with a safety interlock system
that prevents the engine from starting unless the deck
drive is disengaged, the parking brake is engaged, the
steering control levers are in the neutral position and the
operator is in the seat. The interlock system shuts off
the engine if the operator leaves the seat with the
steering control levers not in the neutral position and/or
the cutter blades engaged and the parking brake not
engaged.
14
DUMP VALVE
CONTROL
Figure 4-2 Dump Valve Control
cutter deck in the transport position. Push the foot
pedal forward and lift up on the release lever to
release the cutter deck for normal mowing.
operating temperature of the engine.
Seat belt must be worn at all times when the ROPS is
in the upright and locked position.
WARNING:
Never operate the mower with the interlock
system disconnected or malfunctioning. Do
not disengage or bypass any switch; injury to
yourself and others or property damage could
result.
Section 4
2007 STTDVC
Publicidad
Tabla de contenido
