Assembly; Step 1: Installing The Winding Rods On The Frames - Steinbach 036086 Instrucciones De Uso Manual Original

Assembly

Step 1: Installing the winding rods on the frames

1
17 16
1. Insert the two 85 mm winding rods
The bore holes in the 85 mm winding rods for attaching the rod supports must point outwards.
2. Guide the rod support at the rollers
3. Insert the 85 mm winding rod into the rod support.
Pay attention to the grooves of the winding rod and the rod support.
4. Insert the fixation of the winding rod
5. Position the large disk
support.
6. Push the cover cap
7. Screw the three ST4.2x38 screws
8. Drill three 3 mm bore holes into the rod support through the bore holes of the winding rod.
9. Fix the winding rod onto the rod support with three ST5.3x12 screws
10. Repeat the steps for the rod support at the hand wheel.
2
23
7
11. Position the hand wheel
support at the hand wheel
12. Guide one end of each of the elastic bands
these at regular intervals across the width of the winding rods.
13. Fix the two limiters
14
adjust the width of the solar pool cover winder to your solar pool cover.
4 3
into the 90 mm winding rod
17
into the frame at the rollers
4
.
2
on top and screw the hexagonal screw
8
onto the end of the rod support.
1
into the rod support.
21
5 15
on top and screw the M5x65 screw
7
.
5
15
with the two M5x20 screws
8 24
2
.
16
.
3
with the nut
24
.
20
14
with the cap nut
23
into the grooves of the winding rods and space
in the grooves of the 85 mm winding rods to
22
20 21
1
into the rod
19
22
into the rod
18
13